The incense selenite holder has a shaped stone form with a drilled opening, with pale fibres and small changes around the drilled opening visible across it. The incense holder is listed at approximately 20cm, allowing for small differences around a natural stone edge.
Specifications
- Material: Selenite
- Colour: White
- Approximate size: 20cm
- Use: Incense-stick holder
Keep the incense holder on a level, heat-resistant surface with room for falling ash so paper and fabric are kept away from heat. The long stick should remain upright enough that falling ash lands on the protected surface below. Do not move the holder while the incense is burning. Allow the stone to cool before removing ash since the stone should stay still until it has cooled.
About the natural stone: Because each piece begins with a different section of natural selenite, the mineral lines around the drilled opening will vary from piece to piece. On the incense selenite holder, the direction of the lines can change near an edge, with the overall outline staying recognisable.
A little care: For routine care of the incense holder, wait until the holder is cool, then brush away dry ash; keep oils, abrasive products and wet wipes away from the surface. For storage, keep the incense holder with the opening empty and dry rather than placing it in a damp room or busy drawer.
Delivery Information
Once your order comes through, we get started on it.
Most orders leave us within a couple of working days.
Delivery is normally around 3 working days.
We pack everything carefully so it gets to you safely.